RGBLink VSP 5360 - Manual (Page 94)

6. System Setup and Operation
How to Load the Saved Parameter
VSP 5360 User Manual 94
How to Load the Saved Parameter
Push the [Load] button, the button light is on, and enable the
LOAD function.
Some of the number buttons 0-12 in PRE area are on, some flash and
some are off. The buttons on is ready for recall, and flashes means just
recall. OLED shows as follows:
Push the button on to load, for example, button 1, OLED shows as follows:
RECALL USER CONFIG MODE 1
RECALL IS SUCCESSFUL
PROGRAM INPUT:CV2
PUSH THE LEDS ARE ON TO RECALLLED
Button on is ready for recall
Button flashes means just recall