Document Outline

• CONTENT
• 1. Introduction
  • Chapter Structure
  • How to Use This Guide
  • Terms and Definitions
  • System Overview
  • Application Question
• 2. Hardware Orientation
  • In This Chapter
  • VSP 3600 Back Panel
    • INPUT
      • 13~16: DVI Input
      • 5~8: DVI Loop Out
    • OUTPUT
      • 9~12: VGA Output
      • 17~20: DVI Output
    • CONT
      • Dial Switch
      • 2. 10/100M Interface
      • 3. USB Interface
      • 8. RS232 Interface
    • Switch and Power
      • 21. Switch
      • 22. Power Port
  • VSP 3600 Front Panel
    • Sources
    • Layer
    • Transition
    • Outputs
    • Layer Functions
    • Effects
    • Custom Adjustments
    • Control Button
    • LCD Panel
    • Knob
  • VSP 3600 Front Panel Button Part
    • Sources Part
    • Layer Part
    • Layer Functions Part
    • Outputs Part
    • Transition Part
    • Effects Part
    • Custom Adjustments Part
    • Control Button Part
    • Knob Part
    • LCD Panel Part
• 3. Hardware Installation
  • In This Chapter
  • Safety Precautions
  • Unpacking and Inspection
  • Site Preparation
• 4. Menu Orientation
  • In This Chapter
  • MENU
  • DEV INFO
  • INPUT CONFIG
  • OUTPUT CONFIG
  • LAYER CONFIG
  • VIEW
  • SYSTEM
  • RESET
• 5. Communication Software Guideline
  • In This Chapter
  • Install Software
  • Run Software
    • Language Selection
    • Connection
    • Mode Settings
      • Output Settings
      • Alpha Settings
      • Alpha Speed Settings
      • Color Key Settings
      • Devices Settings
      • Input Port Settings
      • Scale Settings
      • Crop Settings
    • Display Mode
      • Mirror Image and Test Pattern Settings
      • Rotate Settings
      • Layout
      • Load User Mode
      • Save User Mode
      • Split Screen Mode
      • CUT
      • Take
      • Input Config
    • Control
      • IP Setting
      • Factory reset
    • Language
    • Management
      • Advanced Test
    • Script
      • Load Customer Script
    • Save Customer Script
      • Version Explain
      • About
      • Image Display Toolbar
    • Information Toolbar
  • How to control processor through RS232?
  • How to control processor with console software by USB?
• 6. System Setup and Operations
  • In This Chapter
  • How to determine equipment run normally?
  • How to change the output resolution?
  • How to edit and define program?
  • How to edit and define layer?
  • How to add layer?
  • How to clear layer?
  • How to edit and define outputs?
  • How to scale the layer image
  • How to crop the layer image?
  • How to set the position of layer image?
  • How to set independent outputs in PIP effects?
  • How to achieve split function?
  • How to set picture size in split effects?
  • How to rotate layer image?
  • How to achieve color extraction?
  • How to achieve LOGO overlay?
  • How to achieve subtitles superposition?
  • How to save the current setting parameters?
  • How to recall the saved parameters?
• 7. Common Questions and Solution
  • In This Chapter
  • No Output in Large Screen
    • Confirm if there are any input singles
    • Confirm if single output
  • Large Screen Output Flash Point
    • Confirm if preview output is normal
  • Large Screen only Display Part of the Image
    • Signal need to scale
  • No Display in the Second Half Part of Large Screen
    • Resolution is inadequate
  • All Key Lights Light Simultaneously
    • Check if dial switches are normal
• A.Specification
• B.Contact Information
• C. Upgrading Software
  • Main board MCU program upgrading steps