RGBLink CP 3096H User Manual - Manual (Page 56)

5. System Setup and Operation
How to Realize Single Image Switching
CP 3096H User Manual 56
How to Realize Single Image Switching
CP 3096H can realize seamless effects switch between two channels,
choose the signal in PREVIEW area, then push the [TAKE] button, the
signal will be switched to LED display.
For example, switch VGA to LED display, first push the [VGA] button in
PREVIEW area, then push the [TAKE] button or T-bar in effects switch
control area, and the LED display will show VGA signal.
System default the switch time is 1 seconds for [TAKE] button, if need to
adjust the fade time, turn the knob in transition time control area, and set
according to actual need, push the [TAKE] button again, the signal will be
switched to the LED display with the adjusted time.
User can also switch the signal by pushing the signal button in PROGRAM
area, but the signal in monitor will not change.