Chapter 3: software installation & operation – Smart Avi SmartNet-V User Manual
Page 14
Page 14
MNSNV102005Ver1.0
Chapter 3: Software Installation & Operation
Chapter 3: Software Installation & Operation
Chapter 3: Software Installation & Operation
Chapter 3: Software Installation & Operation
Chapter 3: Software Installation & Operation
A/V Split:
A/V Split:
A/V Split:
A/V Split:
A/V Split: Check this box if you need to route audio and video independently, regardless from
which source they originated from. Leave unchecked if you want audio and video signals from the
same input to remain together.
For example, if you wanted to route different video feeds to different locations but wanted all of
them to have the same audio, you should check the box.
Inputs/Outputs:
Inputs/Outputs:
Inputs/Outputs:
Inputs/Outputs:
Inputs/Outputs: Enter the number of Inputs/Outputs your SmartNet-V router has. For now we will
assume that there are 16 inputs and 16 outputs.
Com Port:
Com Port:
Com Port:
Com Port:
Com Port: Select the appropriate com port that your computer is using to access the router.
Router Timeout:
Router Timeout:
Router Timeout:
Router Timeout:
Router Timeout: By default this is 0 meaning the computer acknowledges commands almost
instantly. Sometimes a computer takes longer to respond. This setting should be left at 0. If you
need to change it, it should be no higher than 0.2.
After you have entered in the necessary information click OK.
This will now take you to the Main Routing Window where you can route the different video/audio
connections.
On this screen you will notice the input buttons running down the left side while the output
buttons run across the top. They are each labeled 1 through 16.
Note: The three small colored buttons at the lower right labeled ALL, VIDEO, and AUDIO are not
available if AV Split was not checked when you configured your router.