Teac DV-RA1000 - Manual (Page 13)

2 – Connections
TASCAM DV-RA1000 Owner’s Manual
13
Other connections
WORD SYNC The DV-RA1000 is fitted with three
BNC connectors for standard word sync.
CAUTION
There should be one, and only one clock master in a
setup.
IN receives word sync from an external source, and
OUT is used when the DV-RA1000 is used as the
word sync master in a setup, outputting the frequency
of the current project.
THRU echoes the sync
received at IN and is terminated automatically if
nothing is connected.
NOTE
When in DSD recording mode, the DV-RA1000 inputs
and outputs word sync at 44.1 kHz. Under these condi-
tions, the input sync can be ±6% away from the norm.
USB Connect a suitably-equipped computer using a
USB 2.0 cable. The DV-RA1000 appears as a mass
storage device, requiring no driver software.
The computer can be used to read data files, etc. from
discs loaded in the DV-RA1000, but cannot write
files that can then be played by the DV-RA1000.
CONTROL I/O You can use RS-232C serial con-
trol with the DV-RA1000 by connecting an appropri-
ate cable to this connector. Consult your TASCAM
distributor for details of pin-outs, protocols, etc.
REMOTE IN Connect only the supplied wired RC-
RA1000 remote control unit to this jack.
PHONES Connect a standard set of stereo head-
phones to this front panel 1/4" jack. Adjust the level
with the control above the jack.