Teac MD-CD1 - Manual (Page 27)

7 – CD and MD Playback—Auto Ready
TASCAM MD-CD1 Owner’s Manual
27
Auto Cue function on and off for each deck. (Default
position: OFF)
When the Auto Cue function is on, A_CUE is lit on
the display.
Even when the power is turned off, the Auto Cue set-
ting is maintained.
Setting the sound start position detection
level
Use the “A_CUE LEVEL?” option on the PLAY sub-
menu of the MD menu or CD menu to set the sound
start position detection level. Settings can be made
independently for each deck. The level can be set
between –72 dB and –30 dB in 6 dB increments.
NOTE
When the Auto Cue point is being searched, the >
arrow flashes in the display, and audio output is muted.
Auto Ready
When the Auto Ready function is on, after each track
is played, playback standby mode is entered at the
start of the next track. Even when the Skip function is
used to skip tracks, playback standby mode is
entered at the start of the selected track.
NOTE
When the Auto Cue function is also on, playback
standby mode is entered at the start of the sound on
the selected track, and not the beginning of that track.
Turning the Auto Ready function on and off
Press the AUTO READY key on the remote control
to turn the function on and off.
You can also use the “A_READY?” option on the
PLAY sub-menu of the MD menu or CD menu to
turn the Auto Ready function on and off for each
deck. (Default position: OFF)
When the Auto Ready function is on, A.READY is lit
on the display.
Even when the power is turned off, the Auto Ready
setting is maintained.
Repeat playback
Press the REPEAT key on the remote control to turn
on the Repeat mode. In this mode, all the tracks on
the disc are played continuously. During playback, if
the Repeat mode is turned on, playback continues as
before, and when the last track finishes, playback
resumes from the first track. If Repeat mode is turned
on when the deck is stopped, press the PLAY key to
begin operation. You can also use the “REPEAT?” option in the PLAY
sub-menu of the MD and CD menus to turn the
Repeat mode on and off for each deck.
Combining the Repeat mode with the Program, Sin-
gle-track playback and Random playback functions
will enable Program Repeat, Single-track Repeat and
Random Repeat operations, respectively.
A to B repeat playback
If a specific portion between two points on the disc is
specified, that portion can be played back repeatedly.
1 During playback, press the A-B REPEAT
key on the remote control at the beginning of
the desired portion on the disc.
“A-” flashes on the display.
2 At the end of the desired portion on the disc,
press the A-B REPEAT key on the remote
control again.
“REPEAT” and “A-B” are lit up on the dis-
play, and the desired A-B section will be
played repeatedly.
To cancel A-B Repeat mode and resume nor-
mal playback
Press the A-B REPEAT key once more.
In Random and Program modes, A-B Repeat cannot
function when the specified A-B section spans more
than one track.
When the STOP key is pressed, the specified A-B
section is cancelled.
2ReMD-CD1.fm 27 ページ ２００４年１１月５日 金曜日 午前７時３５分