Teac MD-CD1 - Manual (Page 53)

15 – Message display glossary—Troubleshooting
TASCAM MD-CD1 Owner’s Manual
53
Troubleshooting
There is no power to the unit.
Please check that the power cord is properly plugged
in.
“Disc Error!” is displayed.
The disc may be dirty. Please replace the disc.
Playback is not possible.
This may be due to condensation. In this case,
remove the disc, turn the power on and wait a few
hours, then try again.
No sound is output.
Confirm the connections with the audio system.
Check the volume level, and proper amplifier opera-
tion.
Recording isn’t possible.
• The MD disc is set to write protect. Slide the tab on
the cartridge to the closed position and try again.
• Confirm the connections with the audio system.
• Adjust the recording level.
• The disc may be for playback only. Please replace
it with a recordable MD disc.
• Remaining recording time on the MD is insuffi-
cient. Please delete unwanted tracks or replace the
MD disc.
• Confirm amplifier operation.
Noise or static can be heard.
Please re-position the unit away from strong sources
of magnetism such as a television.
The CD-MD1 does not retain settings.
While settings are retained each time they are made,
in some cases they will not be retained when the
power is turned off too soon. To prevent this from
happening, do not turn off the power right after mak-
ing a setting.
2ReMD-CD1.fm 53 ページ ２００４年１１月５日 金曜日 午前７時３５分