Teac DA-3000 - Manual (Page 54)

54
TASCAM DA-3000
10 – Message Lists
Message Meaning
--- ERROR ---
INFO WRITING.
An error occurred at the end of recording.
--- ERROR ---
General Error
needs to STOP.
A general error occurred.
--- ERROR ---
Unsupported File.
(too many tracks)
This file is not supported.
--- ERROR ---
Unsupported Fs.
The sampling rate is not supported.
- MEDIA ERROR - A media error occurred.
-- PLAY ERROR -- A playback error occurred.
-- PLAY ERROR --
Buffer underrun.
A buffer underrun error occurred.
-- READ ERROR -- An error occurred while reading.
-- REC ERROR -- Recording stopped because an error occurred during recording.
-- REC ERROR --
Buffer overflow.
Recording stopped because a buffer overflow error occurred.
- WRITE ERROR - An error occurred while writing.
- CANNOT DIVIDE -
Duplicate name
error.
Division was not possible because a file already exists with a name that would be used by a new file after
division.
-CANNOT RECORD-
Media Full.
Recording is not possible because there is no open space on the media.
-CANNOT RECORD-
Take limit
reached.
Recording is not possible because the maximum number of files has been reached
- PLAYLIST ERROR -
There are some
unusable entries
There is a problem with the playlist entry information.
--- CAUTION ---
Cannot play
while input
monitoring.
When the Input signal monitoring function is ON, and ADDA Direct mode is also ON, it is not possible to
Play any tracks.
--- CAUTION ---
Cannot turn on.
Cascade mode is
not off.
When Cascade mode is ON, this function is unavailable (ADDA Direct Mode)
--- CAUTION ---
Cannot select as
cascade mode.
ADDA DIRECT - ON.
The Cascade Mode cannot be turned ON because ADDA Direct Mode is already ON.
--- CAUTION ---
There is no
entry.
The unit attempted to Play, etc, but the Playlist has no entries in it, so there is nothing to play.
--- CAUTION ---
Cannot select
as master clock.
Fs convert on.
The Sample Rate Converter (SRC) is already ON, so the Digital Input (DIN) cannot be selected as the
Master Clock.
--- CAUTION ---
Cannot turn on.
D-IN is already
Master Clock.
The Master Clock is already set to the Digital Input "DIN", so the Sample Rate Converter cannot be
enabled.
--- CAUTION ---
Must stop first.
This function or setting cannot be changed right now. Please STOP the unit, then it can be changed.