Making other computer connections – Epson 8200i User Manual
Page 39
Setting Up the Projector
33
Making Other Computer Connections
If you want to connect a computer using the BNC cable or connect a
high-end workstation or a Digital Visual Interface (DVI) source,
follow the instructions below.
Connecting a Computer Using the BNC Cable
Follow these steps to connect a computer to the
Computer 2/
Component Video
interface using the BNC cable:
1. Connect the VGA (D-sub 15-pin) end of the cable to your
computer’s video port.
2. Connect the five connectors at the other end of the cable to the
projector’s
R/Cr/Pr
(red),
G/Y
(green),
B/Cb/Pb
(blue),
H/C Sync
(horizontal sync), and
VSync
(vertical sync) ports, shown below.
3. To display images properly, make sure the BNC parameter in the
projector’s Setting menu is set to
RGB
. See page 69.
4. If you want to hear computer-audio through the projector, you’ll
need an RCA-to-3.5 mm stereo cable (available for purchase from
your electronics store or video dealer). Insert the cable’s 3.5-mm
plug into your computer’s audio-out port. Then attach the RCA
connectors at the other end of the cable to the
S-Audio
and
Audio2
ports of the projector.
Computer 2 /
Component Video
Computer 1
Audio
Mouse/Com
Remote
R/Cr/Pr
B/Cb/Pb
H/C Sync
V Sync
G/Y
BNC connectors