Epson 8200i - Manual (Page 79)

Fine-tuning the Projector 73
Capturing and Saving the Image
Follow these steps to capture and save a logo or image:
1. Display the image (with the projector).
2. Press the Menu button on the control panel or remote control to
display the Main menu.
3. Press the down arrow (control panel) or press down on the Enter
button (remote control) to move to the Capture menu.
4. Press Enter (control panel or remote control) to highlight the
User’s Logo Capture option and press Enter again to select it.
You see the message “Do you use the present image as a user’s
logo?”
5. Select Yes and press Enter . A selection box appears over the
image.
6. Use the arrow buttons on the control panel or the Enter button
on the remote control to select the area of the image you want to
use as the logo. Once you have selected the entire area, press
Enter .
7. When the message “Do you use this image?” appears on the
screen, select Yes and press Enter . If you want to change the area
selected, select No , press Enter and repeat steps 4 through 6.
8. Use the arrow buttons on the control panel or the Enter button
on the remote control to select a zoom rate, and then press Enter .
9. When the message “Do you save the user’s logo?” appears, select
Yes and press Enter . If you do not want to save the logo, select
No .
10. When you see the message “Saving the user’s logo is completed,”
press the Menu or Enter button to return to the Capture menu.
11. Press Menu or Esc to return to the Main menu.
note
Saving the logo may take a
few moments. Do not use the
projector or other sources
(computer, video, speaker,
etc.) while the logo is being
saved.