Epson 8200i - Manual (Page 87)

Maintaining and Transporting the Projector 81
4. Use a screwdriver to loosen the three screws holding the lamp in
place. (You cannot remove these screws.)
5. Lift the handle and pull out the lamp.
6. Gently insert the new lamp as shown below. Make sure it’s
inserted securely.
Tighten the screws on the new lamp.
7. Replace the lamp cover and tighten the cover screws. (Make sure
the lamp cover is securely fastened. The projector won’t turn on if
the lamp cover is open.)
8. Now reset the lamp timer as described in the following section.
handle
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass will result
in premature lamp failure.