Epson 8200i - Manual (Page 55)

Using the Projector 49
4. Press the button for the function you want to use. See pages 50
to 55 for more information.
For some functions, you need to use the Enter button like a
mouse to navigate on the screen. Press on the edge of the button
with your thumb. Or, grasp it between your thumb and finger
and tilt it in the direction you want to move.
5. To access additional buttons, pull down the cover below the Esc
button. (See pages 50 to 53 for instructions on using these
buttons to control the projector.)
The projector may not respond to remote control commands in these
conditions:
■ You are too far away or not within 30 ° to the left or right of and
15 ° above or below the front or rear sensor.
■ The R/C (remote control) switch is in the OFF position
■ Batteries are weak
■ Ambient light is too bright
■ A fluorescent light is shining into the infrared receiver
■ A strong light source (such as direct sunlight) shines into the
infrared receiver
■ Other equipment emitting infrared energy is present (such as a
radiant room heater)
Using the Remote Control as a Wireless Mouse
When you use the remote control as a wireless mouse, you don’t need
to stay near your computer or the projector. First make sure you have
connected the mouse cable between the projector and your computer
with the main cable, as described in Chapter 1.
Note that your computer’s mouse is disabled when you connect the
projector’s mouse cable. If you have a laptop, you cannot use an
external mouse; however, you may still be able to use the computer’s
built-in mouse pointer.
Esc
Menu
Comp1
P in P Preset
Video
Help
- Volume +
E@sy-MP
Auto Resize
Comp2/YCbCr