Epson 8200i - Manual (Page 86)

80 Maintaining and Transporting the Projector
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use. It is
time to replace the lamp when:
■ The projection image gets darker or starts to deteriorate.
■ The projection lamp light is flashing red or orange.
■ The message LAMP REPLACE appears on the screen when the
lamp comes on (after about 1900 hours of use). To maintain
projector brightness and image quality, replace the lamp as soon
as possible.
Contact your dealer or EPSON for a replacement lamp. (See page 92
for information on ordering accessories.) Request part number
ELPLP11 .
1. Turn off the projector and unplug the power cable.
2. Allow the projector to cool down for at least an hour (if it has
been on).
3. Use a screwdriver to loosen the two retaining screws on the lamp
cover. When the screws are loose, lift off the lamp cover. (You
cannot remove these screws from the cover.
)
note
You can check to see how
many hours the lamp has
been used. See page 75.
warning
Let the lamp cool before
replacing it. Also, do not
touch the glass portion of the
lamp assembly. Touching the
glass will result in premature
lamp failure.