Epson 8200i - Manual (Page 54)

48 Using the Projector
■ Press the Tracking – and Tracking + buttons to eliminate the
vertical stripes.
■ Press the Sync – and Sync + buttons to eliminate flashing,
blurring, or vertical noise on the screen image.
Using the Remote Control
The remote control lets you access your projector’s features from
almost anywhere in the room—up to 32 feet away. You can use it to
turn the projector on and off, zoom the image, and display the
projector’s menus, for example.
If you have connected the mouse cable (as described in Chapter 1),
you can also use the remote control as a wireless mouse to run your
presentation.
Before you can use the remote control, you need to install the
batteries, as described on page 12. Then follow these steps:
1. Push up the R/C switch on the side of the remote control to turn
it on.
2. Press the round light button. The other buttons on the remote
light up temporarily. If they don’t light up, you need to change
the batteries. See page 12 for instructions.
3. Point the remote at the projector or at the screen.
Sync.
Sync.
T
ra
c
k
in
g
T
ra
c
ki
n
g
note
Images will be projected more
vividly if you adjust the
Tracking before the Sync.
Sync.
Sync.
T
ra
c
k in
g
T
ra
c
ki
n
g
note
You must also be within
± 30 ° vertically and ± 1 5 °
horizontally from the front
or rear sensor.
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1 5
2 4
Enter
Esc
ON/OFF
switch
light
button
cover