Epson 8200i - Manual (Page 72)

66 Fine-tuning the Projector
Saving and Recalling Computer Settings
When you are projecting from a computer source, you can save and
recall settings (resolution, tracking, sync signal, and position) for up to
five different sessions. This is useful if you use more than one
computer with the projector; you can save the settings for each one
and recall them when necessary. Follow these steps to save the current
session settings:
1. Press the Menu button on the control panel or remote control to
display the Main menu.
2. Press Enter to select the Video menu.
3. Use the down arrow (control panel) or Enter button to move
down to the Preset option and press Enter . You see the Preset
Selection menu with the current resolution setting displayed.
4. Press Enter to assign it to the next available number.
5. Press Enter again. When you see the “Overwrite?” prompt, select
Yes or No and press Enter .
6. Press Esc to return to the Video menu.
When you want to use a saved setting, press the Preset button on the
remote control. You see the setting for session number 1 displayed in
yellow at the top right of the screen. To select another number, press
the
Preset button again until the setting number you want is
displayed. The projector will reset itself according to the selected
setting.
note
If you want to overwrite an
existing setting, move to the
setting and press
Enter .
When the confirmation
message appears, choose
Yes
and press Enter .