EXP Computer C4077-90960 - Manual (Page 150)

Top Cover
1 Remove Control Panel (see Figure 6-2), and remove (1) screw, CH102
(Figure 6-8, callout 1).
2 Open the Diverter Assembly access door and remove (1) screw, CH102
(Figure 6-8, callout 2).
3 Open the top cover door and remove (1) screw, CH102 (Figure 6-9,
callout 3).
C a u t i o n Be careful not to damage the Face-Down Bin Full sensor flag (Figure 6-9,
callout 4) when removing the top cover.
4 Lift (and hold) the top cover door up and carefully pull out on the cover to
release the retaining tab (Figure 6-8, callout 5).
5 Hold the Face-Down Bin (Figure 6-8, callout 6) down while carefully and
slowly lifting the top cover straight up until it clears the Face-Down Bin
Full sensor flag and the Delivery Unit.
To Reinstall:
C a u t i o n Be careful not to damage the Face-Down Bin Full sensor flag (Figure 6-9,
callout 4) when replacing the top cover.
1 Hold the top cover door up and the Face-Down bin (Figure 6-8, callout 6)
down while lowering the cover into position.
2 Refer to Figure 6-9, callout 4. Slide the Face-Down Bin under the
Face-Down Bin Full sensor flag, and make sure that the cam (Figure 6-9,
callout 4) at the rear of the top cover door is properly positioned while
lowering the top cover into place.
3 Make sure that the top cover is seated properly and that the retaining tabs
are in place before replacing the screws.
6
Removal and Replacement
Removal and Replacement 6-23