EXP Computer C4077-90960 - Manual (Page 395)

Configuring TCP/IP Parameters
The HP JetAdmin utility for UNIX (sold separately) may be used to
configure TCP/IP parameters. If you do not have the HP JetAdmin utility
for UNIX, or you are using a UNIX system other than HP-UX, Solaris, or
SunOS, you may use the control panel of the printer to configure these
TCP/IP parameters manually:
•
Usage of the bootp file for configuration parameters (the default is to use
the bootp file) IP address (4 bytes)
•
Subnet mask (4 bytes)
•
Syslog server IP address (4 bytes)
•
Default gateway (4 bytes)
TCP connection timeout (in seconds)
To manually configure TCP/IP parameters:
1 Press [Item] . CFG TCP/IP=NO * appears.
2 Press [+] . CFG TCP/IP=YES appears.
3 Press [Select] . CFG TCP/IP=YES * appears.
4 Press [Item] to manually configure TCP.IP parameters. BOOTP=YES *
appears. If you keep BOOTP=YES *, then the values for the TCP/IP
parameters will be provided by the bootp file, no other TCP/IP configuring is
necessary.
5 Press [+] to change the value of the BOOTP=parameter. BOOTP = NO
appears.
6 Press [Select] to save the selection. BOOTP=NO * appears. If you selected
BOOTP=NO *, then you will be prompted to configure each of the TCP/IP
parameters.
7 Press [Item] to continue configuring.*** IP BYTE 1 = ALUE * *** appears.
8 Press [+] until the value of the first byte of the IP address appears on the
control panel display. Note that if you Press and hold [+] , the value will
scroll rapidly.
9 Press [Select] to save the value.
10 Press [Item] to continue. Repeat steps 8 and 9 to configure the remaining
bytes of the IP address.
11 Repeat steps 8 through 10 to configure the subnet mask bytes (SM), syslog
server IP address (LG), default gateway (GW), and timeout (TIMEOUT).
12 If no other protocol is enabled, Press [On Line] . After completing this guide
refer to the HP JetDirect Network Interface Configuration Guide for
configuration instructions.
B-8 I/O Information