Tray 2 and 3 adjustment procedure – EXP Computer C4077-90960 User Manual
Page 82
Tray 2 and 3 Adjustment Procedure
The paper trays are mechanically aligned to the printer chassis at the
factory. Perform this procedure ONLY if a paper tray has been replaced
with a tray other than the original factory installed unit, or if the top
margin of the image area is off-center more than 0.5 mm (0.02 in.) The
adjustment procedure is identical for Trays 2 and 3.
N o t e
Before performing this procedure, check that the margins in your software
application are properly set.
1
Load the paper tray being tested with letter or A4 size paper.
2
Perform a 1-sheet Paper Path Test from that tray (see Paper Path Test
under Test Menu in Chapter 3).
3
Refer to Figure 4-1 and compare distance A to distance B.
Image Area Margins
(Top Of Page)
Figure 4-1
4
Maintenance &
Adjustments
Maintenance and Adjustments 4-7