ACTi TCM-6630 User Manual
Page 41
TCM-6630 Hardware User’s Manual
SEQUENCE LINE
There are eight sets of sequence lines built in the speed dome camera. Using LEFT/RIGHT
direction keys to select a line first and then set its sequence points.
SEQUENCE POINT
Up to 32 points can be specified for each sequence line. The sequence points represent the
orders of the preset points that the dome will automatically run, and the bellowing setup items,
PRESET POSITION, SPEED, and DWELL TIME, are related to this item.
PRESET POSITION
Users can assign a specific preset position to the selected sequence point with this item.
SPEED
Users can set the Speed that the dome goes to the next sequence point, and setup speed
range is from 1 ~ 15. Refer to below table for more information.
PAN (degree/sec.)
TILT (degree/sec.)
Speed 1
10
8
Speed 2
23
12
Speed 3
35
22
Speed 4
45
30
Speed 5
55
40
Speed 6
65
50
Speed 7
75
58
Speed 8
185
185
Speed 9
205
210
Speed 10
225
240
Speed 11
250
275
Speed 12
280
305
Speed 13
320
335
Speed 14
365
365
Speed 15
400
400
DWELL TIME
The DWELL TIME is the duration time that the speed dome will stay at the sequence point,
and the range is from <0> to <127> seconds. The speed dome will go to the next sequence
point when the DWELL TIME is up. If the setting is <0>, the speed dome will stay at this
sequence point until users manually move the speed dome.