ARAG BRAVO130 User Manual
Page 24
24
9.1.2
Four-sensor configuration
The following information will appear on the display:
D
A
B
C
Fig. 20
A • the distribution value, the instantaneous
speed or the pressure value measured by the
transducer; the value displayed will depend on how
the computer was programmed during installation.
B and C • data relative to the activated sensors
(
B for the left side and C for the right side of the
tractor).
D • the number of the active field.
2 SENSORS - 4 SPRAYING BOOMS
Fig. 21
3a) To activate sensor
S1, which controls the
opening and closing of
R1 spraying boom, hold key
pressed and then press the
key.
3b) To activate sensor
S2, which controls the
opening and closing of
R2 spraying boom, hold key
pressed and then press the
key.
3c) To activate sensor
S3, which controls the
opening and closing of
R3 spraying boom, hold key
pressed and then press the
key.
3d) To activate sensor
S4, which controls the
opening and closing of
R4 spraying boom, hold key
pressed and then press the
key.
It is possible to enable automatic operation for only one sensor at a time.
The symbol appears on the display when at least one of the two sensors, on the
LEFT (
S1-S2) is active.
The symbol appears on the display when at least one of the two sensors, on the
RIGHT (
S3-S4) is active.
When all the sensors are enabled, the display will show the following information:
D
A
B
C
Fig. 22
A • the distribution value, the instantaneous
speed or the pressure value measured by the
transducer; the value displayed will depend on how
the computer was programmed during installation.
B and C • data relative to the activated sensors
(
B for the left side and C for the right side of the
tractor): the value between parentheses is the
number of the active sensor).
D • the number of the active field.
When
displays in place of the sensor number, this indicates that the sensor in
question has detected a tree: when one or more booms are in line with the plants, and
if the valves have been enabled (section valve switches up), treatment is initiated.
If at least one of the sensor is disabled, automatic operating mode changes to semi-
automatic mode (sec.
9.3
).