2 getting started – ARM Electronics RDVR16A User Manual
Page 13
2.2 GETTING STARTED
2.2 GETTING STARTED
1)
Before using the DVR, please have the HDDs installed ready.
(refer to Appendix
(refer to Appendix
#1 for installation of
#1 for installation of
HDDs
HDDs
)
).
2)
Connect the AC Power Cord to Power Adapter and plug into an electrical outlet.
The Standby LED light will turn to red.
Press the Power button. The POWER LED will be red. It takes approximately 10
to 15 seconds to boot the system with the message : “ SYSTEM INIT. ”, “HDD
DETECTING”, and “HDD DETECTED”.
3)
Before operating the DVR, please set up the system time first.
(for setting
(for setting
system time, please refer to
system time, please refer to
“
“
DATE
DATE
”
”
settings).
settings).
9
NOTE :
When “HDD not found”
message shows up,
please refer to
appendix
appendix
# 1
# 1
. It may result from
the improper installation
of the HDD.
Channel Title
Available Capacity
of Internal HDDs
System Time
Under HDD
Overwrite Mode
SYSTEM INIT…
DETECTING MASTER HDD
OK
DETECTING SLAVE HDD
FAIL
DETECTING DISKARRAY
FAIL
VERSION 1016-06-D3-04-V354-02
SYSTEM NTSC
- 787 -