Installing a power module – H3C Technologies H3C S5800 Series Switches User Manual

Page 64

Advertising
background image

54

Installing/Removing a power module (for the S5800-60C-PWR
and the S5800-32F)

Installing a power module

To install a power module into the S5800-60C-PWR or S5800-32F switch:

1.

Wear an ESD-preventive wrist strap, ensure a good skin contact, and make sure that the
ESD-preventive wrist strap is correctly grounded.

2.

If the power module slot is covered by a filler panel, remove the filler panel first.

3.

Before installing a PSR750-A or PSR750-D power module to the S5800-60C-PWR switch, remove
the filler module, as shown in

Figure 53

.

4.

Unpack the power module and check that the power module model is correct.

5.

Correctly orient the power module with the power module slot, grasp the handle of the module
with one hand and support the module bottom with the other, and slide the module slowly along

the guide rails into the slot (see callout 1 in

Figure 54

or

Figure 55

). The slot is foolproof. If you

cannot insert the power module into the slot, re-orient the power module rather than use excessive

force to push it in.

6.

Fasten the captive screws on the power module with a Philips screwdriver to secure the power
module in the chassis (see callout 2 in

Figure 54

or

Figure 55

).

Figure 53 Remove the filler module before installing a PSR750-A or PSR750-D power module

Figure 54 Install a PSR750-A power module

1

2

Advertising