H3C Technologies H3C S3100 Series Switches - Manual (Page 537)

Operation Manual – FTP and TFTP
H3C S3100-52P Ethernet Switch Chapter 1 FTP and TFTP Configuration
1-5
Note:
z
The specified interface must be an existing one. Otherwise a prompt appears to
show the configuration fails.
z
The value of argument ip-address must be an IP address on the device where the
configuration is performed. Otherwise a prompt appears to show the configuration
fails.
z
You may specify only one source interface or source IP address for the FTP at one
time. That is, only one of the commands ftp-server source-interface and
ftp-server source-ip
can be valid at one time. If you execute both of them, the new
setting will overwrite the original one.
IV. Disconnecting a specified user
On the FTP server, you can disconnect a specified user from the FTP server to secure
the network.
Table 1-5
Disconnect a specified user
Operation Command Description
Enter system view
system-view
—
On the FTP server,
disconnect a specified
user from the FTP server
ftp disconnect
user-name
Required
Note:
If you attempt to disconnect a user that is uploading/downloading data to/from the FTP
server that is acted by an S3100-52P Ethernet switch, the S3100-52P Ethernet switch
will disconnect the user after the data transmission is completed.
V. Displaying FTP server information
After the above configurations, you can run the display command in any view to
display the running information of the FTP server and verify your configurations.