Preparing for installation, Safety recommendations, General safety recommendations – H3C Technologies H3C SR8800 User Manual

Page 27: Electricity safety, Esd prevention

Advertising
background image

17

Preparing for installation

Safety recommendations

To avoid any equipment damage or bodily injury caused by improper use, read the following safety

recommendations before installation. Note that the recommendations do not cover every possible
hazardous condition.

General safety recommendations

Take adequate safety measures to avoid injury and router damage. For example, wear an ESD wrist
strap.

Make sure the ground is dry and flat and anti-slip measures are in place.

Keep the chassis clean and dust-free.

Do not place the router on a moist area and avoid liquid surrounding the router.

Keep the chassis and installation tools away from walk areas.

Move the router and heavy components (such as the power modules or chassis) with other people

rather than doing that alone.

Electricity safety

Clear the work area of possible hazards, such as ungrounded power extension cables, missing
safety grounds, and wet floors.

Locate the emergency power-off router in the room before installation. Shut the power off at once in
case accident occurs.

Unplug all the external cables (including power cables) before moving the chassis.

Do not work alone if potential hazardous conditions exist, for example, when the router has power.

Always check that the power has been disconnected.

ESD prevention

To prevent the electronic components from being damaged by the electrostatic discharge (ESD), you
should not only take ESD measures where the router is located, but also take the following precautions:

Always wear an ESD wrist strap when installing components, especially the electronic printed circuit
boards.

Hold a PCB by its edges. Do not touch any electronic components or printed circuit.

Check the resistance of the ESD wrist strap for safety. The resistance reading should be in the range
of 1 to 10 megohm (Mohm) between human body and the ground.

To attach the ESD wrist strap:

1.

Wear the wrist strap on your wrist.

Advertising