Installing an ac power module, Installing an neps3500-a ac power frame – H3C Technologies H3C SR8800 User Manual

Page 45

Advertising
background image

35

Installing an AC power module

Installing NEPS800-A and NEPS2000-A AC power modules

The NEPS800-A and NEPS2000-A power modules are installed in the same way. The following takes an

NEPS2000-A for example.
To install an NEPS2000-A AC power module:

1.

Remove the air filter frame of the power module, and gently pull the AC power module handle out.

2.

Holding the handle of the power module with one hand and supporting the bottom of the power
module with the other hand, insert the power module slowly along the guide rails to fully seat it in
the backplane.

3.

Fasten the mounting screws on the power module panel with a Phillips screwdriver.

4.

Cover the power module with the removed air filter frame.

Figure 30 Installing an NEPS2000-A power module

Installing an NEPS3500-A AC power frame

1.

Push in the power frame slowly along the guide rails to fully seat it in the backplane.

2.

Fasten the mounting screws on the power frame panel with a Phillips screwdriver.

Figure 31 Installing an NEPS3500-A power frame

Advertising