H3C Technologies H3C SecPath F1000-E - Manual (Page 37)

29
Figure 32 Configuring ACL 2010
• Select Permit in Operation.
• Select Source IP Address and enter 10.1.1.0 in the field.
• Enter 0.0.0.255 in Source Wildcard.
• Click Apply.
# Enable strict URPF check in zone B.
• Select Intrusion Detection > URPF Check from the navigation tree and perform the following
operations, as shown in
Figure 33 .
Figure 33 Configuring URPF in zone B
• Select zoneB in Security Zone.
• Select Enable URPF.
• Select ACL and enter 2010 in the field.
• Select Strict in Type of Check.
• Click Apply.
Configuring Device A
# Configure the interface IP addresses and security zones they belong to. (Details not shown.)
# Enable strict URPF check in zone A.