H3C Technologies H3C SecPath F1000-E User Manual
Page 38
Advertising
30
•
Select Intrusion Detection > URPF Check from the navigation tree and perform the following
operations, as shown in
.
Figure 34 Configuring URPF on zone A
•
Select zoneA in Security Zone.
•
Select Enable URPF.
•
Select Allow Default Route.
•
Select Strict in Type of Check.
•
Click Apply.
Advertising
This manual is related to the following products:
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS