H3C Technologies H3C Intelligent Management Center - Manual (Page 103)

94
2. On the Alarm Notification page, click the Copy icon in the Message Notification list associated
with the notification rule you want to copy.
3. On the Copy Message Notification page, rename the rule using a unique name.
4. Make any necessary modifications to the rule.
5. Click OK.
Deleting a message notification rule
To delete a message notification rule:
1. Click Alarm > CPE Alarm > Alarm Notification.
2. On the Alarm Notification page, click the Delete icon in the Message Notification list associated
with the notification rule you want to delete.
3. Click OK.
Managing alarm forwarding
The system sends alarm information in the Syslog format to the specified third-party server according to
the configured alarm forwarding rule.
Adding or modifying an alarm forwarding rule
On the Alarm Notification page, you can add one or more new notification rules or modify existing
ones.
To add or modify an alarm forwarding rule:
1. Click Alarm > CPE Alarm > Alarm Notification.
2. In the Alarm Forwarding pane on the Alarm Notification page, do one of the following:
{
To add a new rule, click Add to open the Add Alarm Forwarding page, and then proceed with
step 3.
{
To modify a rule, click its Modify icon to open the page for modifying the rule, and then
proceed with step 4.
3. Enter a Rule Name for the notification rule.
NOTE:
This step is mandatory for adding an alarm forwarding rule. After you create a rule, you cannot
modify its name.
4. Set one or more conditions for the notification rule. The logical relation among conditions is AND.
{
Destination IP Address—Enter the IP address of the destination management system.
{
Port—Specify the port of the destination management system.
{
Concerned Alarm Levels—Set your required alarm severity levels by selecting the check boxes
of the corresponding alarm levels.
{
Concerned CPEs—Do one of the following:
− Select All CPEs to forward alarms for all CPEs.
− Select Selected CPEs to specify CPEs for forwarding. Then click Select CPE to the right of the
new CPE list that appears, and select the CPEs on the resulting CPE Query popup.
You can remove unwanted CPEs from this list by selecting the CPE, and then clicking Delete
CPE. Only the alarms from the selected CPEs are forwarded.