H3C Technologies H3C Intelligent Management Center - Manual (Page 86)

77
Testing a rule
After completing the rule adding procedure, you can check if the rule works by using the test function.
1. On the Add Compliance Policy page, click the Test icon .
2. On the Rule Test page, enter the violations in the Test Content text box, and then click Test to
display the testing results.
For example, if you enter 123 in the Match Patterns box, and the Match Mode is Loose Match, then:
{
When you enter 123 in the Test Content, the test result is Test content matches rule.
{
When you enter 456 in the Test Content, the test result is Test content does not match rule.
Viewing compliance policy details
1. Click Service > BIMS > Compliance Center > Compliance Policy.
2. On the Compliance Policy page, click a target policy name.
3. On the Compliance Policy Details page, check the Name, Type, and Description in the Basic
Information pane.
4. Check the Name, Type, Severity Level, and the Check Type for each rule in the Rule List pane. To
open the Rule Test page, click the Test icon .
Modifying the compliance policy list
1. Click Service > BIMS > Compliance Center > Compliance Policy.
2. On the Compliance Policy page, click the Modify icon .
3. On the target policy Modify Compliance Policy page, modify the description in the Basic
Information pane, and then add, modify or import a rule as needed in the Rule List.
4. Click OK.
NOTE:
The system-defined policy cannot be modified.
Deleting the compliance policy list
1. Click Service > BIMS > Compliance Center > Compliance Policy.
2. On the Compliance Policy page, click the Delete icon to delete the target policy.
NOTE:
The system-defined policy cannot be deleted.
Enabling/disabling the compliance policy
1. Click Service > BIMS > Compliance Center > Compliance Policy.
2. On the Compliance Policy page, click Enable/Disable.
To enable or disable all compliance policies: