H3C Technologies H3C Intelligent Management Center - Manual (Page 61)

52
3. According to the task type, the system navigates to the corresponding task wizard for you to
configure the deployment task.
For more information, see "
Deploying configurations and software using the Deployment Guide ."
Executing a deployment task immediately
If a deployment task is in the Waiting, Expired, or Finished status, and its operation result is Partially
Succeeded or Failed, you can use this function to start or re-run the tasks immediately as required.
You cannot execute a deployment task immediately that meets any one of the following conditions:
• The task is an auto deployment task.
• The type of task is Auto Restore Configuration to Baseline or Auto Restore Software to Baseline.
To execute a deployment task immediately:
1. Click Service > BIMS > Configuration Management > Deployment Task.
All deployment tasks are displayed in the Deployment Task List.
2. Select the check boxes associated with the tasks you want to execute immediately, and then click
Run.
3. Click OK.
Suspending/resuming a deployment task
If a deployment task is in the Waiting or Executing status, you can use this function to stop executing it.
Also, you can resume suspended tasks.
If you suspend a task in the Executing status, the started deployments in this task continue until the
deployments are finished, while those yet to be started are not executed.
NOTE:
If you suspend an auto CPE configuration deployment task or auto CPE software deployment task, the auto
deployment task is disabled.
You cannot suspend an Auto Restore Configuration to Baseline or Auto Restore Software to Baseline
task.
To execute a deployment task immediately:
1. Click Service > BIMS > Configuration Management > Deployment Task.
All deployment tasks are displayed in the Deployment Task List.
2. Select the check boxes associated with the tasks you want to suspend, and then click Suspend.
3. Click OK.
4. In the Deployment Task List, select the suspended tasks, and then click Resume to resume the tasks.
Deleting a deployment task
You can delete a deployment task or multiple deployment tasks in batches.
You cannot delete a deployment task that meets any one of the following conditions:
• The task is in the Executing status.