H3C Technologies H3C Intelligent Management Center - Manual (Page 83)

74
{
Execute Result—The execute result as Failed.
Skipped CPEs
{
CPE Name—The skipped CPE name.
{
IP Address—The skipped CPE IP address.
{
Skip Reason—The skip reason.
4. Close the page to go back to the Task History page.
Querying a check task history
1. Click Service > BIMS > Compliance Center > Task History.
2. In the Query pane on the Task History page, specify the Task Name and Time Range, and then
click Query.
3. Click Reset to reset the query conditions.
Deleting a check task history
1. Click Service > BIMS > Compliance Center > Task History.
2. On the Task History page, select the check box to the left of the target task history.
3. Click Delete.
Refreshing the task history list
1. Click Service > BIMS > Compliance Center > Task History.
2. On the Task History page, click Refresh.
Managing compliance policy
Compliance policy is the core function of the Compliance Center and should be configured at the very
beginning when you decide to start the compliance check procedure. BIMS allows you to add, modify,
delete, and enable or disable a compliance policy. Furthermore, nine system-defined policies are
provided based on typical scenarios which group the most common rules for use. You can select to use
them directly or customize new policies according to your requirements.
A compliance policy is composed of several rules. Generally, you can add a new rule into a policy
manually, or import it automatically. When you finish adding a rule, a rule test function helps you confirm
that the check results meet your requirements.
Viewing the compliance policy list
1. Click Service > BIMS > Compliance Center > Compliance Policy.
All available compliance policies are displayed in the Policy List pane on the Compliance Policy
page.
2. You can query a compliance policy by name in the Query pane.
The Policy List includes: