Grass Valley K2 Storage System Instruction Manual v.3.2 Aug.01 2007 - Manual (Page 41)

July 3, 2007 K2 Storage System Instruction Manual 41
Setting up the L2 RAID chassis
cable, which must be connected.
Assign chassis address on Expansion chassis
Every chassis must have a chassis address. The Level two RAID chassis address is
fixed at 0, so no configuration is required. However, if you have a L2 RAID
Expansion chassis you must set its chassis address to 1 as shown in the following
illustration. Also verify that the diagnostic ID switches are in the position shown.
Install Ethernet and diagnostic cabling as shown.
Ethernet Switch
Ethernet cable
L2 RAID Chassis
L2 RAID
Expansion
Chassis
(if installed)
Diagnostic cable
Connect to a
control port