Grass Valley PLS200 - Manual (Page 30)

Chapter 1 Installing the Hardware
8 PLS200 Library Installation and Operation
Install the Library Into a Rack
Follow these instructions to install the library into a standard EIA 19-inch rack.
WARNING: The library weighs 137 – 167 pounds (62 – 76 kg). You need at
least 4 people, or 2 people and a small fork lift, to lift it.
Make sure you install the library in the lowest possible location in the rack
and that the rack is equipped with extension support legs.
Make sure you extend the support legs before installing the library in the rack
or when sliding it out of the rack.
Tools required
You need the following tools to install the library into a rack
• T-15 TORX screwdriver
• T-25 TORX screwdriver
!