Grass Valley PLS200 - Manual (Page 41)

Prepare and Install Cartridges
PLS200 Library Installation and Operation 19
Install Data Cartridges in the Magazines
The empty magazines are packed in the box of accessories shipped with the
PLS200.
1. Place the magazine on its feet with the single mounting guide toward the
right, as shown in Figure 1-14.
2. Position each cartridge so that the bar code label is on top and the
write-protect switch is toward the front (see Figure 1-14).
3. Insert the cartridge into the magazine slot.
NOTE: Very little force is needed to install a data cartridge. If it does not snap into
place easily or if it protrudes further than the magazine’s center rib, check
the orientation of the cartridge.
Figure 1-14 Installing data cartridges in the magazine