HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 11)

11
Line segment in a contour G1-Geo
G1 defines a line segment in a turning contour.
Parameters
X, Z: End point (X diameter value)
A:
Angle to rotary axis – for angle direction see illustration
Q: Select point of intersection – default: 0
■ Q=0: Near intersection
■ Q=1: Far intersection
B: Chamfer/rounding
■ B is undefined: Tangential transition
■ B=0: Nontangential transition
■ B>0: Rounding radius
■ B<0: Chamfer width
E: Special feed-rate factor (0 < E † 1) – default: 1
(special feed rate = active feed rate * E)
Basic elements f
o
r
cont
our descr
iption
Starting point of turning contour G0 Geo
G0 defines the starting point of a turning contour.
Parameters
X, Z: Starting point of the contour (X diameter value)