HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 30)

30
Linear slot on the end face G301-Geo
G301 defines a linear slot on the front/rear end face.
Parameters
XK,YK: Center of slot
A:
Angle of slot length (reference: XK-axis) – default: 0°
K: Slot length
B: Slot width
P: Depth/height – no entry: ”P” from G308
■ P<0: Pocket
■ P>0: Island
Circular slot on the front end G302-/G303-Geo
G302/G303 defines a circular slot on the front/rear end face.
Parameters
I, J:
Center of slot curvature
R: Curvature radius (reference: center point path of the slot)
A: Angle of slot starting point (reference: XK-axis) – default: 0
W: Angle of slot end point (reference: XK-axis)
B: Slot width
P: Depth/height – no entry: ”P” from G308
■ P<0: Pocket
■ P>0: Island
Example: G302-Geo
Figur
es on end f
ace cont
our