HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 231)

HEIDENHAIN iTNC 530 231
8.3 Cy
cles f
o
r Dr
illing
, T
a
p
p
ing
and
Th
read Millin
g
G84 TAPPING
With a floating tap holder
G85 RIGID TAPPING
Without a floating tap holder
G86 THREAD CUTTING
For integration into OEM cycles
G206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance
G207 RIGID TAPPING NEW
Without a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance
G209 TAPPING W/ CHIP BRKG
Without a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance, chip breaking
G262 THREAD MILLING
Cycle for milling a thread in pre-drilled material
G263 THREAD MLLNG/CNTSNKG
Cycle for milling a thread in pre-drilled material and
machining a countersunk chamfer
G264 THREAD DRILLING/MLLNG
Cycle for drilling into the solid material with
subsequent milling of the thread with a tool
G265 HEL.THREAD DRLG/MLG
Cycle for milling the thread into the solid material
G267 OUTSIDE THREAD MLLNG
Cycle for milling an external thread and machining a
countersunk chamfer
Cycle Soft key