6 optional block skip, Function, Erasing the “/” character – HEIDENHAIN iTNC 530 (340 422) ISO programming User Manual
Page 470: 6 optio n al blo c k skip 11.6 optional block skip
Advertising
470
11 Test Run and Program Run
1
1
.6 Optio
n
al Blo
c
k Skip
11.6 Optional Block Skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
U
U
U
U
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
U
U
U
U
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Erasing the “/” character
U
U
U
U
In the Programming and Editing mode you select the block in which
the character is to be erased.
U
U
U
U
Erase the “/” character.
This function does not work for G99 blocks.
After a power interruption the control returns to the most
recently selected setting.
Advertising