HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 527)

HEIDENHAIN iTNC 530 527
13.3 T
e
c
h
n
ical In
fo
rm
atio
n
Software option 1
Rotary table machining
m
Programming of cylindrical contours as if in two axes
m
Feed rate in length per minute
Coordinate transformations m Tilting the working plane
Interpolation
m
Circle in 3 axes (with tilted working plane)
Software option 2
3-D machining o Motion control with minimum jerk
o 3-D compensation through surface normal vectors
o
Using the electronic handwheel to change the angle of the swivel head during program
run without affecting the position of the tool point (TCPM = Tool Center Point
Management)
o
Keeping the tool normal to the contour
o Tool radius compensation normal to the direction of traverse and the tool direction
o Spline interpolation
Interpolation
o
Line in 5 axes (subject to export permit)
Block processing time o 0.5 ms