HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 518)

518 13 Tables and Overviews
13.1 Gener
a
l User P
a
ra
met
e
rs
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements MP7471
0 to 99 999 [mm/min]
Compatibility machine parameters for
datum tables MP7475
Datum shifts are referenced to the workpiece datum: 0
If the value 1 was entered in older TNC controls or in controls with
software 340 420-xx, datum shifts were referenced to the machine
datum. This function is no longer available. You must now use the preset
table instead of datum tables referenced to REF (see “Datum
management with the preset table” on page 54).
Machining and program run