HEIDENHAIN iTNC 530 (340 422) ISO programming - Manual (Page 479)

HEIDENHAIN iTNC 530 479
12.4 Set
ting
the D
a
ta In
te
rf
ace
s
Assign
This function sets the destination for the transferred data.
Applications:
n
Transferring values with Q parameter function D15
The TNC mode of operation determines whether the PRINT or PRINT
TEST function is used:
You can set PRINT and PRINT TEST as follows:
File names
TNC mode of operation Transfer function
Program Run, Single Block PRINT
Program Run, Full Sequence PRINT
Test Run PRINT TEST
Function Path
Output data via RS-232 RS232:\....
Output data via RS-422 RS422:\....
Save data to the TNC’s hard disk TNC:\....
Save the data in the same directory as the
program with D15. - vacant -
Data Operating mode File name
Values with D15 Program Run %FN15RUN.A
Values with D15 Test Run %FN15SIM.A