HEIDENHAIN 530 (340 49x-07) - Manual (Page 14)

New functions with 340 49x
-03
14
New functions with 340 49x-03
„ The Adaptive Feed Control (AFC) was introduced (see “Adaptive
Feed Control Software Option (AFC)” on page 425).
„ The global parameter settings function makes it possible to set
various transformations and settings in the program run modes (see
“Global Program Settings (Software Option)” on page 414).
„ The TNC now features a context-sensitive help system, the
TNCguide (see “The Context-Sensitive Help System TNCguide
(FCL3 Function)” on page 164).
„ Now you can extract point files from DXF files(see “Selecting and
storing machining positions” on page 277).
„ Now, in the DXF converter, you can divide or lengthen laterally
joined contour elements (see “Dividing, extending and shortening
contour elements” on page 276).
„ In the PLANE function the working plane can now also be defined
directly by its axis angle (see “Tilting the working plane through axis
angle: PLANE AXIAL (FCL 3 function)” on page 482).
„ In Cycle 22 ROUGH-OUT, you can define a feed-rate reduction if the
tool is cutting on its entire circumference (FCL3 function, see User's
Manual for Cycles).
„ In Cycle 208 BORE MILLING, you can now choose between climb or
up-cut milling (see User's Manual for Cycles).
„ String processing has been introduced in Q parameter programming
(see “String Parameters” on page 340).
„ A screen saver can be activated through machine parameter 7392
(see “General User Parameters” on page 678).
„ The TNC now also supports a network connection over the NFS V3
protocol (see “Ethernet Interface” on page 643).
„ The maximum manageable number of tools in a pocket table was
increased to 9999 (see “Pocket table for tool changer” on page
188).
„ Parallel programming is possible with smarT.NC (see “Select
smarT.NC programs” on page 129).
„ The system time can now be set through the MOD function (see
“Setting the System Time” on page 669).