HEIDENHAIN 530 (340 49x-07) - Manual (Page 17)

New functions with 340 49x
-05
HEIDENHAIN iTNC 530 17
New functions with 340 49x-05
„ DCM: Integrated fixture management (see “Fixture Monitoring
(DCM Software Option)” on page 401)
„ DCM: Collision checking in the Test Run mode (see “Collision
monitoring in the Test Run mode of operation” on page 399)
„ DCM: Management of tool-carrier kinematics has been simplified
(see “Tool-carrier kinematics” on page 186)
„ Processing DXF data: Fast point selection via mouse area (see
“Quick selection of hole positions in an area defined by the mouse”
on page 279)
„ Processing DXF data: Fast point selection via diameter input (see
“Quick selection of hole positions in an area defined by the mouse”
on page 279)
„ DXF data processing: Polyline support was integrated (see
“Processing DXF Files (Software Option)” on page 268)
„ AFC: Smallest occurring feed rate will now also be saved in the log
file (see “Log file” on page 433)
„ AFC: Monitoring for tool breakage/tool wear (see “Tool
breakage/tool wear monitoring” on page 435)
„ AFC: Direct monitoring of spindle load (see “Spindle load
monitoring” on page 435)
„ Global program settings: Function also partially effective with
M91/M92 blocks (see “Global Program Settings (Software Option)”
on page 414)
„ Pallet preset table added (see "Pallet datum management with the
pallet preset table", page 523 or see "Application", page 520 or see
"Storing measured values in the pallet preset table", page 570 or see
"Saving the basic rotation in the preset table", page 576)
„ The additional status display now has an additional tab, i.e. PAL, on
which an active pallet preset is displayed (see “General pallet
information (PAL tab)” on page 93)
„ New tool management (see “Tool management (software option)”
on page 200)
„ New column R2TOL in the tool table (see “Tool table: Tool data
required for automatic tool measurement” on page 180)
„ Tools can now also be selected during tool call by soft key directly
from TOOL.T (see “Calling tool data” on page 191)
„ TNCguide: Context sensitivity has been improved in that when the
cursor is engaged it jumps to the appropriate description (see
“Calling the TNCguide” on page 165)
„ Lithuanian dialog added, machine parameter 7230 (see “List of
general user parameters” on page 679)
„ M116 allowed in combination with M128 (see “Feed rate in
mm/min on rotary axes A, B, C: M116 (software option 1)” on page
496)
„ Introduction of local and nonvolatile Q parameters QL and QR (see
“Principle and Overview” on page 302)
„ The MOD function can now test the data medium (see “Checking
the Data Carrier” on page 668)