HEIDENHAIN 530 (340 49x-07) - Manual (Page 26)

Chang
e
d functions with 340 49x
-04
26
Changed functions with 340 49x-04
„ DCM: Retraction after collision simplified (see "Collision monitoring
in the manual operating modes", page 396)
„ The input range for polar angles was increased (see “Circular path
CP around pole CC” on page 242)
„ The value range for Q-parameter assignment was increased (see
"Programming notes", page 304)
„ The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key.
„ The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode.
„ Windows XP is now used on the dual-processor version (see
“Introduction” on page 710)
„ Conversion from FK to H was moved to the special functions (SPEC
FCT).
„ Filtering of contours was moved to the special functions (SPEC
FCT).
„ Loading of values from the pocket calculator was changed (see “To
transfer the calculated value into the program” on page 153)