HEIDENHAIN 530 (340 49x-07) - Manual (Page 19)

New functions 340 49x
-06
HEIDENHAIN iTNC 530 19
New functions 340 49x-06
„ The new HR 520 and HR 550 FS handwheels are supported (see
“Traversing with electronic handwheels” on page 546)
„ New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks, see "3-D tool radius compensation depending on
the tool’s contact angle (3D-ToolComp software option)", page 513)
„ 3-D line graphics is now also possible in full-screen mode (see “3-D
Line Graphics (FCL2 Function)” on page 156)
„ A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see “Calling any
program as a subprogram” on page 289)
„ DCM: Saving and restoring of fixture situations
„ DCM: The form for test program generation now also contains icons
and tooltips (see “Check the position of the measured fixture” on
page 406)
„ DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
„ DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired.(see “Operating
FixtureWizard” on page 403)
„ DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
„ DCM: A library with standard chucking equipment is available now
(see “Fixture templates” on page 402)
„ DCM: Tool carrier management (see “Tool Holder Management
(DCM Software Option)” on page 411)
„ In the Test Run mode, the working plane can now by defined
manually (see “Setting a tilted working plane for the test run” on
page 618)
„ In Manual mode the RW-3D mode for position display is now also
available (see “Position Display Types” on page 660)
„ Entries in the tool table TOOL.T (see “Tool table: Standard tool data”
on page 176)
„ New DR2TABLE column for definition of a compensation table for
tool radius compensation depending on the tool’s contact angle
„ New LAST_USE column, into which the TNC enters the date and
time of the last tool call
„ Q parameter programming: QS string parameters can now also be
used for jump addresses of conditional jumps, subprograms or
program section repeats (see "Calling a subprogram", page 287, see
"Calling a program section repeat", page 288 and see "Programming
If-Then decisions", page 313)
„ The generation of tool usage lists in the Program Run modes can be
configured in a form (see “Settings for the tool usage test” on page
197)
„ The behavior during deletion of tools from the tool table can now be
influenced via machine parameter 7263 see "Editing tool tables",
page 183