HEIDENHAIN 530 (340 49x-07) - Manual (Page 15)

New functions with 340 49x
-04
HEIDENHAIN iTNC 530 15
New functions with 340 49x-04
„ The global parameter settings function makes it possible to activate
handwheel superimposed traverse in the active tool axis direction
(virtual axis) (see “Virtual axis VT” on page 424).
„ Machining patterns can now easily be defined with PATTERN DEF
(see User's Manual for Cycles).
„ Program defaults valid globally can now be defined for machining
cycles (see User's Manual for Cycles).
„ Now, in Cycle 209 TAPPING WITH CHIP BREAKING, you can define a
factor for the retraction shaft speed, so that you can depart the hole
faster (see User's Manual for Cycles).
„ In Cycle 22 ROUGH-OUT, you can now define the fine-roughing
strategy (see User's Manual for Cycles).
„ In the new Cycle 270 CONTOUR TRAIN DATA, you can define the type
of approach of Cycle 25 CONTOUR TRAIN (see User's Manual for
Cycles).
„ New Q-parameter function for reading a system datum was
introduced (see "Copying system data to a string parameter", page
345).
„ New functions for copying, moving and deleting files from within
the NC program were introduced.
„ DCM: Collision objects can now be shown three-dimensionally
during machining (see "Graphic depiction of the protected space
(FCL4 function)", page 398).
„ DXF converter: New settings possibility introduced, with which the
TNC automatically selects the circle center when loading points
from circular elements (see "Basic settings", page 270).
„ DXF converter: Element information is shown in an additional info
window (see "Selecting and saving a contour", page 274).
„ AFC: A line diagram is now shown in the additional AFC status
display (see “Adaptive Feed Control (AFC tab, software option)” on
page 98).
„ AFC: Control settings parameters selectable by machine tool builder
(see “Adaptive Feed Control Software Option (AFC)” on page 425).
„ AFC: The spindle reference load currently being taught is shown in
a pop-up window in the teach-in mode. In addition, the learning
phase can be restarted at any time via soft key (see “Recording a
teach-in cut” on page 429).
„ AFC: The dependent file <name>.H.AFC.DEP can now also be
modified in the Programming and Editing operating mode (see
“Recording a teach-in cut” on page 429).