HEIDENHAIN 530 (340 49x-07) - Manual (Page 51)

HEIDENHAIN iTNC 530 51
14.1 Switch-On, Switch-Off ..... 540
Switch-on ..... 540
Switch-off ..... 543
14.2 Moving the Machine Axes ..... 544
Note ..... 544
Moving the axis using the machine axis direction buttons ..... 544
Incremental jog positioning ..... 545
Traversing with electronic handwheels ..... 546
14.3 Spindle Speed S, Feed Rate F and Miscellaneous Functions M ..... 556
Function ..... 556
Entering values ..... 556
Changing the spindle speed and feed rate ..... 557
14.4 Datum Setting without a 3-D Touch Probe ..... 558
Note ..... 558
Preparation ..... 558
Workpiece presetting with axis keys ..... 559
Datum management with the preset table ..... 560
14.5 Using the 3-D Touch Probe ..... 566
Overview ..... 566
Selecting probe cycles ..... 567
Recording measured values from the touch-probe cycles ..... 567
Writing the measured values from touch probe cycles in datum tables ..... 568
Writing the measured values from touch probe cycles in the preset table ..... 569
Storing measured values in the pallet preset table ..... 570
14.6 Calibrating a 3-D Touch Probe ..... 571
Introduction ..... 571
Calibrating the effective length ..... 571
Calibrating the effective radius and compensating center misalignment ..... 572
Displaying calibration values ..... 573
Managing more than one block of calibrating data ..... 573
14.7 Compensating Workpiece Misalignment with a 3-D Touch Probe ..... 574
Introduction ..... 574
Basic rotation using 2 points: ..... 576
Determining basic rotation using 2 holes/studs: ..... 578
Workpiece alignment using 2 points ..... 579
14 Manual Operation and Setup ..... 539