HEIDENHAIN 530 (340 49x-07) - Manual (Page 22)

New F
u
nctions with 340 49x
-07
22
„ Improvements to the global program settings (GS):
„ All the form data can now be set and reset under program control
(see “Technical prerequisites” on page 416)
„ Handwheel superimposition value VT can be reset when tool is
changed (see “Virtual axis VT” on page 424)
„ If the Swapping Axes function is active, it is now permitted to
position to machine-based positions on the axes that have not
been swapped
„ Using the new SEL PGM function you can assign variable program
names via QS string parameters call them with CALL SELECTED (see
“Define program call” on page 444)
„ Improvements to the tool table TOOL.T
„ Using the FIND ACTIVE TOOL NAMES soft key you can check
whether identical tool names are defined in the tool table (see
"Editing tool tables" page 183)
„ The input range of the delta values DL, DR and DR2 have been
increased to 999.9999 mm (see "Tool table: Standard tool data"
page 176)
„ The following additional functions are now available in the expanded
tool management (see “Tool management (software option)” on
page 200):
„ Importing of tool data in CSV format (see “Import tool data” on
page 205)
„ Exporting of tool data in CSV format (see “Export the tool data”
on page 206)
„ Marking and deleting of selectable tool data (see “Delete marked
tool data” on page 207)
„ Inserting of tool indices (see “Operating the tool management”
on page 202)
„ New cycle 225 Engraving (see User’s Manual for Cycle
Programming)
„ New cycle 276 Contour Train (see User’s Manual for Cycle
Programming)
„ New cycle 290 Interpolation Turning (software option, see User’s
Manual for Cycle Programming)
„ In the thread milling cycles 26x a separate feed rate is now available
for tangential approach to the thread (see User’s Manual for Cycle
Programming)
„ The following improvements were made to the KinematicsOpt
cycles (see User’s Manual for Conversational Programming):
„ Newer, faster optimization algorithm
„ It is no longer necessary to run a separate measurement series for
position optimization after angle optimization
„ Return of the offset errors (change of machine datum) to the
parameters Q147-149
„ More plane measuring points for ball measurement
„ Rotary axes that are not configured are ignored by TNC when
executing the cycle