HEIDENHAIN 530 (340 49x-07) - Manual (Page 48)

48
12.1 Functions for Multiple Axis Machining ..... 466
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 467
Introduction ..... 467
Define the PLANE function ..... 469
Position display ..... 469
Reset the PLANE function ..... 470
Defining the machining plane with space angles: PLANE SPATIAL ..... 471
Defining the machining plane with projection angles: PROJECTED PLANE ..... 473
Defining the machining plane with Euler angles: EULER PLANE ..... 475
Defining the working plane with two vectors: VECTOR PLANE ..... 477
Defining the machining plane via three points: PLANE POINTS ..... 479
Defining the machining plane with a single, incremental spatial angle: PLANE RELATIVE ..... 481
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 482
Specifying the positioning behavior of the PLANE function ..... 484
12.3 Inclined-Tool Machining in the Tilted Plane ..... 489
Function ..... 489
Inclined-tool machining via incremental traverse of a rotary axis ..... 489
Inclined-tool machining via normal vectors ..... 490
12.4 TCPM FUNCTION (Software Option 2) ..... 491
Function ..... 491
Define TCPM FUNCTION ..... 492
Mode of action of the programmed feed rate ..... 492
Interpretation of the programmed rotary axis coordinates ..... 493
Type of interpolation between the starting and end position ..... 494
Reset TCPM FUNCTION ..... 495
12.5 Miscellaneous Functions for Rotary Axes ..... 496
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 496
Shorter-path traverse of rotary axes: M126 ..... 497
Reducing display of a rotary axis to a value less than 360°: M94 ..... 498
Automatic compensation of machine geometry when working with tilted axes: M114 (software option 2) ..... 499
Maintaining the position of the tool tip when positioning with tilted axes (TCPM): M128 (software
option 2) ..... 501
Exact stop at corners with nontangential transitions: M134 ..... 504
Selecting tilting axes: M138 ..... 504
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 505
12 Programming: Multiple Axis Machining ..... 465