Yaskawa Sigma-II Large Capacity - Manual (Page 3)

Using fully-closed I/F unit
(JUSP-FC100)
Please use SGDV, which has a
fully-closed option module.
Please change the feedback signal
from the linear scale to ± 1V analog
signal output from 90 degree phase
difference 2-phase pulse train. Then
use the serial conversion unit
(JZDP-D00 -000-E type).
Using DeviceNet I/F unit
(JUSP-NS300)
Currently we don’t provide a
replacement model in ∑-V series.
Please inquire to the factory.
Using ProfieBus I/F unit
(JUSP-NS500)
Currently we don’t provide a
replacement model in ∑-V series.
Please inquire to the factory.
Using INDEXER module
(JUSP-NS600)
Currently we don’t provide a
replacement model in ∑-V series.
Please inquire to the factory.
Using Application Module
with SGDH Servo
Amplifier
Using MECHATROLINK I/F unit
(JUSP-NS100/-NS115)
Please use MECHATROLINK-II
communication reference type servo
amplifier (SGDV- 1 type).
However, SGDH +
JUSP-NS100/NS115 type and
SGDV- 1 type are corresponding
to different commands. Therefore the
software change of the host controller
side may be necessary.
Please use SGDV, which has a
fully-closed option module when
performing the fully-closed control.
Please change the feedback signal
from the linear scale to ± 1V analog
signal output from 90 degree phase
difference 2-phase pulse train. Then
please use the serial conversion unit
(JZDP-D00 -000-E type).